Cisco Implementing cisco ip routing Sample Questions:

1. Refer to the exhibit.

R1 and R2 have been configured to share routing information via EIGRP. What will be the result of the configuration section shown for R2?

A) Any routes learned by R2 from the interface tied to the 172.16.0.0 network will not be advertised to neighbors on the 192.168.2.0 network.
B) Only routes learned by R2 from the interface tied to the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network.
C) Only the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network.
D) All networks, except the 172.16.0.0 network will be advertised to neighbors on the
192.168.2.0 network.

2. What are two possible causes for EIGRP Stuck-In-Active routers? (Choose Two)

A) A failure causes traffic on a link between two neighboring routers to flow in only one direction (unidirectional link).
B) Some query or reply packets are lost between the routers.
C) The neighboring router starts receiving route updates from this router.
D) The neighboring router stops receiving ACK packets from this router.

3. A router has two paths to reach another network in a different autonomous system. Neither route was generated by the local router and both routes have the same default weight and local preference values. Which statement is true about how BGP would select the best path?

A) The router will prefer the route with the lower MED.
B) To influence one route to be preferred, its default local preference value will be changed via the use of the command bgp default local-preference 50.
C) The router will prefer the shortest autonomous system path.
D) If the command bgp always-compare-med has been given, then the router will prefer the route with the highest MED.

4. Given the accompanying output, which additional command is needed to redistribute IGRP into EIGRP?
Router eigrp 123
Network 10.10.10.0
No auto-summary
!
Router igrp 123
Network 172.16.0.0
Network 172.17.0.0

A) Under the router eigrp mode add redistribute igrp 123 subnets
B) Under the router igrp mode add redistribute eigrp 123
C) Under the router eigrp mode add redistribute igrp 123
D) None, EIGRP and IGRP are automatically redistributed in this instance.

5. Which of the following are methods EIGRP uses to initially populate (seed) its EIGRP topology table, before learning topology data from neighbors? (Choose two.)

A) By adding all subnets listed by the show ip route static command
B) By adding subnets redistributed on the local router from another routing source
C) By adding the subnets of working interfaces over which static neighbors have been defined
D) By adding all subnets listed by the show ip route connected command

Solutions: